Release notes xxter update 4.1.5

Harm Elzinga
Harm Elzinga Administrator
in Release notes - xxter

Release notes xxter update 4.1.5

  • New feature: you can now disable the HTTP trigger port on the device, or set it to use HTTPS instead of HTTP.
  • New feature: default the xxter KNX tunnel will not allow the writing of the BCU key, to prevent misuse. (security feature). If you want to write the BCU key of any KNX device using the KNX tunnel on the xxter, first enable this under protocol settings.
  • Sonos change, when selecting a playlist or favorite, the current playlist will be replaced instead of the playlist being added to the queue.
  • Fixes a problem with would prevent factory reset
  • KNX module bugfix, which cause the telegrams to be too slow.
  • Send value was not always send on KNX bus correctly, this has been fixed
  • KNX module bugfix, which cause problems with coreV1 and some other problems in specific situations.
  • KNX remote programming with extended telegrams could mismatch sequence counter, which would confuse ETS. This has been fixed


Categorieën